(PDF) Effect of additives on void structure of foamed ...

34th Cement and Concrete Science Conference 14-17 September 2014 University of Sheffield Effect of additives on void structure of foamed concrete A.A. Hilal, N.H. Thom and A.R. Dawson Department of Civil Engineering, University of Nottingham ABSTRACT This paper describes a study done to investigate the effect of additives on the air-void structure of foamed concrete by characterising size and ...

View Products

Cement Chemistry and Additives - Schlumberger

cement faces its toughest challenge under ground—in oil and gas wells where envi- ronmental conditions are far more severe than any encountered on the earth's surface. This artic e outlines the chemistry of port- land cement, the variety used to cement casings in wells and provide zona isolation, and explains how additives faci itate cement

View Products

Effect of cement additives on unconfined compressive ...

The effect of nine cement additives on the unconfined compressive strength (UCS) of warm and ice-rich frozen soils was analyzed. After 7 days of curing at −1 °C, the UCS at −1 °C, the freezing-point depression and changes in the water content of soil samples were measured to explore the additive effect and mechanism.

View Products

Is there any harmful effects of concrete additives on the ...

Concrete additives are added to the mixture of water cement and aggregate in small quantities to increase the durability of the concrete, to fix concrete behavior and to control setting or hardening.

View Products

Types of Admixtures of Concrete & Cement | Chemical, Mineral

A material other than water, aggregates, or cement that is used as an ingredient of concrete or mortar to control setting and early hardening, workability, or to provide additional cementing properties. Admixtures are generally used to alter the properties of concrete (such as increased workability or reduced water content, acceleration or retardation of setting time,

View Products

Properties and Uses of Different Types of Concrete Admixtures

concrete admixtures are the ingredients other than cement, water, and aggregates that impart a specific quality to either plastic (fresh) mix or the hardened concrete (ASTM C496). ... Properties and Uses of Different Types of Concrete Admixtures. ... Effect can be reduced in moderate strength concrete by lowering water cement ratio and ...

View Products

Effect of Additives on Asphalt Properties - AAPT

V.53-84, p.495. Use of Indirect Tension Measurements to Examine the Effect of Additives on Asphalt Concrete Durability. Gilmore, D.W.; Lottman, R.P. and Scherocman, J.A. V.55-86, p.120. Effects of Selected Asphalts and Antistrip Additives on Tensile Strength of Laboratory-Compacted Marshall Specimens-A Moisture Susceptibility Study.

View Products

Superplasticizer - Wikipedia

Superplasticizers (SP's), also known as high range water reducers, are additives used in making high strength concrete.Plasticers are chemical compounds that enable the production of concrete with ca. 15% less water content. Superplasticers allow reduction in water content by 30% or more.

View Products

How Admixtures Affect Integrally Colored Concrete ...

Jan 01, 2010· "In general, anything you add to a concrete mix can and will affect the color of integral concrete," says Chris Sullivan, vice president of sales and marketing for ChemSystems Inc., a manufacturer of decorative concrete additives. "With additives, color change can range anywhere from very slight to quite dramatic."

View Products

Revealing the Mystery of Admixtures: Water-Reducing and ...

May 29, 2010· Effects on concrete Water-reducing admixtures are primarily used to reduce the water-cementitious content of concrete, thus increasing strength. In some cases, they can be used to increase the workability or slump of the concrete providing for easier placement.

View Products

Composition of cement - engr.psu.edu

Composition of cement. Introduction Portland cement gets its strength from chemical reactions between the cement and water. The process is known as hydration.This is a complex process that is best understood by first understanding the chemical composition of cement.

View Products

Effect of Clay Additives on Curing and Sensing Behavior of ...

Class H oil well cement was modified by adding about 0.04% of the conductive filler with a water to cement ratio of 0.38 to get smart cement. In order to characterize the effect of different nano clay additives, 2"x4" cylindrical specimens were prepared with 0.5% (by weight of cement) of nano clay (Laponite or Bentonite).

View Products

Air entrainment and its effects in concrete • Aggregate ...

Because the use of chemical and mineral admixtures in addition to air-entraining agents has become common practice, concrete users are always concerned about the effects of these admixtures on the air-void system and durability of concrete. Effects of water reducers, retarders, and accelerators were widely investigated by many researchers.

View Products

What are the types and functions of concrete admixtures ...

Jul 19, 2018· 1. Common kind of concrete admixture 1.1 Classification of concrete admixture Based on admixture's effect, they can be classified as four types: (1) Admixture that can improve performance such as workability of concrete mixture. (2) Adjust concret...

View Products

Effects of Different Mineral Admixtures on the Properties ...

Feb 18, 2014· Nevertheless, effect of mineral admixtures on the properties of fresh concrete is very important as these properties may affect the durability and mechanical properties of concrete. Comparative studies have been done such as the effect of blast furnace slag and fly ash on the hydration of fresh cement paste, effect of silica fume (SF ...

View Products

Admixtures for Concrete - University of Memphis

Chapter 6 Admixtures for Concrete Table 6-1. Concrete Admixtures by Classification (Continued) Type of admixture Desired effect Material Superplasticizer* and Increase flowability with retarded set See superplasticizers and also water reducers retarder (ASTM C 1017, Reduce water–cement ratio Type 2)

View Products

Salt & Concrete: Does adding salt to concrete make it 1.4 ...

Salt and concrete do not act well together. As previously mentioned, you may see some benefits early on by way of higher strengths in different forms, but these benefits don't last for long term. Salt, or any chemical containing chlorides, tends t...

View Products

Concrete Additives - Concrete, Cement & Masonry - The Home ...

The Bull-Bond 1 Gal. SABAKRETE is a liquid The Bull-Bond 1 Gal. SABAKRETE is a liquid solution of synthetic rubber that is non re-emulsifiable and highly water resistant. This premium water-based latex is added to cementitious mixes and/or used as a bonding adhesive to achieve permanent adhesion to concrete surfaces and to greatly improve the properties of Portland ...

View Products

Chemical Admixtures - cement.org

The effectiveness of an admixture depends on several factors including: type and amount of cement, water content, mixing time, slump, and temperatures of the concrete and air. Sometimes, effects similar to those achieved through the addition of admixtures can be achieved by altering the concrete mixture-reducing the water-cement ratio, adding ...

View Products

Effect of Usage of Admixture in Concrete - nbmcw.com

Anything other than these if added in concrete either before or during mixing to alter the properties to our desired requirement are termed as admixtures. The use of admixtures offers certain beneficial effects to concrete like improved workability, acceleration or retardation of setting time, reduce water cement …

View Products

Effects of Different Mineral Admixtures on the Properties ...

This paper presents a review of the properties of fresh concrete including workability, heat of hydration, setting time, bleeding, and reactivity by using mineral admixtures fly ash (FA), silica fume (SF), ground granulated blast furnace slag (GGBS), metakaolin (MK), and rice husk ash (RHA). Comparison of normal and high-strength concrete in which cement has been partially supplemented by ...

View Products

Effect of additives in cement - asbreganzona.ch

Additives in Sorel Cement Based Materials Impact Study. polypropylene fibres to Sorel cement significantly affects the reduction of shrinkage cracks and micro cracks (Bensted 1989) The use of additives is a simple way of minimizing water absorption and permeability in Sorel cement Additives can also reduce product penetration by. Chat Online

View Products

The Optimization of Calcareous Fly Ash-Added Cement ...

This is an experimental study which explores the physical, mechanical, and economic factors involved in the production of type CEM II A-B/W cement. In this context, 4 cement additives were used in two different dosages (200 and 800 g/t). Class C fly ash was used for composite cement production at ratios of 5%, 20%, and 35%.

View Products

Effects of Sugarcane's Bagasse Ash Additive on Portland ...

89 Y asir Aw ad Allah Mohamed et al.: Effects of Sugarcane's Bagasse Ash Additive on Portland Cement Properties the Bagasse ash using more advanced methods like X-ray Diffraction (XRD) Analysis.

View Products

How Concrete is Made - cement.org

Other Ingredients. Almost any natural water that is drinkable and has no pronounced taste or odor may be used as mixing water for concrete. Excessive impurities in mixing water not only may affect setting time and concrete strength, but can also cause efflorescence, staining, corrosion of reinforcement, volume instability, and reduced durability.

View Products

Use of Water Reducers, Retarders, and Superplasticizer

Reducing the water content in a concrete mixture should be done in such a way so that complete cement hydration process may take place and sufficient workability of concrete is maintained for placement and consolidation during construction. The w/cm needed for cement to complete its hydration process ranges from 0.22 to 0.25.

View Products

The Science Behind It: Effects of Silane Additives on ...

Mar 29, 2018· Silane coupling agents were used in varying proportions, and the effect of the coupling agent content on mortar properties was studied. Experimental Procedures. Materials and Preparation. The cement used was No. 42.5 ordinary Portland cement (OPC) made in China. The integral silane mortar additive was (γglycidoxypropyl) methyldimethoxysilane ...

View Products

Seven Must-Use Concrete Admixtures (Additives)

The Bull-Bond 1 Gal. SABAKRETE is a liquid The Bull-Bond 1 Gal. SABAKRETE is a liquid solution of synthetic rubber that is non re-emulsifiable and highly water resistant. This premium water-based latex is added to cementitious mixes and/or used as a bonding adhesive to achieve permanent adhesion to concrete surfaces and to greatly improve the properties of Portland ...

View Products